Sears is proud to be the dependable name in Upper Arlington, OH for everything heating and cooling related. Our highly-skilled professionals have what they need to tackle any job, diagnose any problem and complete any repair. Your comfort is our number one priority.
Find out why we’ve been held in such high esteem since we were founded in 1950. Read reviews from the good folks of Upper Arlington, OH below.
Local Reviews
for Upper Arlington, OH
Powered by Nearby NowOur Reviews by City
Great Service!!
Eric - Upper Arlington, OH
We recently moved back into the area and when it comes to anything related to HVAC our choice was simple! Sears Heating and Cooling! Professional, thorough, and made appropriate recommendations given the age of our furnace. Simple transaction and confident going into the Winter.
Great service
Michelle - Upper Arlington, OH
Josh was great! Super knowledgeable and friendly. Will be using Sears again in the future for sure
Josh S.
Double ac check Rheem and Bryant ac 2007 r22 and r410
Josh S.
Ac check Bryant 2007 r410 filter 16-25-14
Robby D.
Called for cooling oudoor unit cycled on properly. Indoor unit faulted and blower failed to run. Found proper voltage going to blower informed customer is issues customer stated with age of system he is interested in replacement. Scheduled for Tuesday morning
Ramon R.
Diagnosed faulty condenser fan motor
Ramon R.
Performed air conditioner maintenance on Carrier unit
Mike B.
Performing maintenance on a 2018 rheem air conditioner
Josh S.
Ac check. Capacitor is good 50/5
Mike B.
Performing maintenance on a 2015 rheem air conditioner.
Josh S.
Rheem 2017 ac check. System working good capacitor is good. Contactor is good
Robby D.
Technician returned to complete repair. Performed repair and cycled unit multiple times. 55 degree delta t. 0 co in supply. Cycled unit with jumper at control board. Unit cycled on and off properly. Cycled unit multiple times through thermostat to ensure proper operation. Unit cycled each time properly without fault or concern. No further concerns at this time.
Robby D.
Upon arrival system was showing code 3 for pressure switch issue, technician preformed diagnostic steps to find board not properly distributing voltage to turn on combustion exhaust system customer wanted to open up a supply house after hours however found no answer at any supply houses. Will call back tomorrow with pricing and availability.
Mike B.
Performing maintenance on a Bryant ductless mini split system with one indoor head.
Mike B.
Performing maintenance on a 2007 carrier 2 stage conventional gas furnace.
Ramon R.
Replaced Trane furnace main limit
Ramon R.
Diagnosed faulty high limit switch.
Josh S.
Furnace check on two furnaces 90% single stage Bryant 2009: and 2013 80% 2 stage system
Mike B.
Customer mentioned new system having issues. Doesn’t want to come on when calling from thermostat at times. I found venting drooping in a long run and holding water causing a code 32 for pressure sensors not closing or reopening. I drained water from pipe and put in more strap to obtain a better drop to allow water to flow into furnace. Gasket connection between flue and inducer was leaking. Corrected and set in place and tighten all clamps. No longer leaking water. Changed water panel 12 for humidifier. When testing found small pinhole leak in feeder tube and leaking water onto the floor. Went over on page sh3. Chose sh3a. Replaced feeder tube system and adjusted water pressure and tested. All okay at this time. Completed mechanical, safety, and performance test on furnace. All okay at this time.
Ramon R.
Serviced flame sensor and circuit board replaced.
Josh S.
Unit needed cleaned. Filter is clean Did cleaning and checked co. Co in flue is 2 ppm And none in home System is up and running set to 70
Mike B.
Thermostat is low located in bedroom directly next to bathroom with heated floors. Discussed with customer and agreed on moving to hallway near living room. Unable to use current thermostat and equipment module as it requires a three wire configuration to communicate. Went over options on page hh28 to install red link module and vision pro 8000 full wireless thermostat. Chose to go with hh28c. Completed repairs and cycled furnace. Completed performance testing. Combustion analysis good. All okay at this time.
Mike B.
Performing maintenance on a 2014 and a 2007 Bryant gas furnace. Serviced mr slim ductless system.
Jamie S.
Cost to replace furnace. Cost to install high-efficiency furnace with April air humidifier and air cleaner
Josh S.
ennox pulse from 1986. 90% replaced 20-25-1 filter and showed customer no rom for humidification system Changed fresh air filter for pulse large added tabs and flushed drain line
Ramon R.
Performed air conditioner maintenance on Bryant units
Josh S.
Water tank is working I checked combustion, passed tested No leaks Tank is very clean and no dryer in this area Very clean place Flame sensing system is good 2006 BW
